|
TEL:
415-242-1551 |
| |
Respirators
|
|
|
 |
CARRY-AIR™ AND
WALL-AIR™ FILTRATION PANELS
Allegro's Air
Filtration Panels convert shop air used for
pneumatic tools and equipment to clean breathable
air. They provide from 1 to 8 airline respirators
a portable source of up to 15, 30, 60 or 100 CFM
of breathable air from 5-125 psig. The 3-stage
filtration system purifies compressed air removing
water, oil and particulate contaminants. An
optional carbon monoxide monitor, which can be
operated in AC or DC mode, activates an audible
alarm when the concentration of CO exceeds 10 ppm
(set for 5 ppm in Canada). The pressure regulator
includes a pressure gauge and adjustment knob with
locking ring. An adjustable pressure relief valve
protects the CO monitor and respirators in the
event of regulator failure. The Carry-Air
AC/DC-powered unit is housed in a rugged Pelican
case for portability and protection. It includes a
support stand for stability and up-right
operation. An AC/DC powered Wall-Mount unit is
also available. Available with and without CO
monitors. All models meet NIOSH requirements for
point-of-attachment. |
|
 |
MULTI-REGULATOR AIR
FILTRATION PANEL
The unique design of
this panel allows each regulator to be
individually adjusted at different pressure
settings, allowing as well, separate outlets for
air tools. The viewing window on the case allows
monitoring of pressure gauges. A 16 gauge steel
stand for support is included as well as all brass
plumbing with quick-disconnect Hansen couplers.
|
|
|
|
REMOTE CO ALARM The
Remote CO Alarm System uses a 50' cable to go with
workers into the work area and effectively warn of
the presence of carbon monoxide in the air source
with a 90 decibel alarm, and in very noisy
environments, a flashing strobe light. The system
is housed in a rugged Pelican carry case or may be
wall mounted, and attached to any Allegro Air
Filtration Panel.
|
|
 |
POINT-OF-ATTACHMENT AIR CONTROL SYSTEM This
Point-of-Attachment (POA) Air Control System
connects to any breathing air source. It's housed
in a Pelican carry case that can be wall-mounted
and includes an adjustable pressure regulator,
pressure gauge and a pressure relief valve. This
POA system meets NIOSH requirements for point of
attachment. Maximum regulator inlet pressure is
150 psi. |
|
 |
SOURCE PRE-FILTER Where
air quality is especially low, this free standing
or wall-mounted particulate assembly helps extend
the life of the filter panels disposable filters
by removing liquids and contaminates down to 5
microns. It is equipped with an adjustable
regulator pressure gauge and meets the NIOSH
requirement for point-of-attachment.
|
|
 |
CO MONITOR CALIBRATION TEST KIT Used to
test the accuracy of the CO Monitor on Allegro’s
CarryAir, Wall-Air or Oil-Less Compressor. Kit
includes a 17 liter cylinder each of oxygen and
CO, a constant flow pressure regulator with gauge
and tubing in a plastic carrying case.
|
|
 |
CO MONITOR "BUMP TEST" KIT
A
compact, lightweight and convenient way to make a
quick check of CO Monitors. It eliminates the need
for weekly or monthly calibrations. Includes an 11
liter cylinder and a balloon adapter and two
balloons. |
|
 |
1-WORKER HP HOOD
SYSTEM
These systems are the
perfect answer to a one worker situation. It comes
w/Fully Disposable Tyvek Hood, 50' Hose, 1-Worker
Carry Air Filtration Panel. Available w/Adjustable
Flow Control Valve, Personal Air Cooler, or Air
Temp Controller. |
|
|
|
|
|
